If you are not familiar with the xTool M1, it is an innovative laser cutting and engraving machine that can cut and engrave over 500 materials! This is a beginner set up and review that I hope will make your initial set up easier.
Install the built-in ventilation system. You don’t even need any tools. Just hand screw the 4 screws into the connector base, secure the hose and tighten with the included metal hose clasp.
You will need to vent your xTool out a window or door when in use, so be sure to set it up with that in mind. If you do not have a window or door available, you will need to use the xTool smoke purifier.
Open the xTool Creative Space website and download the installers.Click “run the file” and complete the installation on your computer. It's very user-friendly and a quick install.
Now it’s time to attach the included point blade to the laser module. The M1 includes 5 blades, which is a great feature. Just remove the red cap from the blade and place it into the housing, then back into the machine.
If you are working with wood or other materials you want to place the included triangular prisms into the machine.These allow for better air circulation and cleaner cutting.
Power on the machine and wait for the indicator to turn a steady white. Place your material into the machine. I used a piece of 3 mm basswood that was included with the M1.
Add the design you want from the Creative Space Software. I went with a ghost for Halloween. Hit refresh on your computer software and the camera will show the inside with the image.
There is a learning curve as with any new machine. Start with a small project and watch the training videos included on the xTool page. Most of all-have fun with it!